Menu
Cart 0
2003-2009 Dodge Ram 2500/3500 Control Arms for 4-5" of Suspension Lift

2003-2009 Dodge Ram 2500/3500 Control Arms for 4-5" of Suspension Lift

  • 26995


We are pleased to bring you our exclusive design tubular control arms for the:
2003-2009 Dodge Ram 2500/2300
and
2003-2009 Dodge 1500 Megacab
 

Product Description: 
These is a complete set of (4) 2 upper and 2 lower brand new tubular control arms for the front of a 2003-2009 Dodge Ram 2500/3500 4x4 w/ 4" to 5" of lift. (works on the 2003-2009 Megacab 1500 4x4 as well) We are the original manufacturer of these, and have built them for other sellers on here for several years. We recently made the decision to offer them directly to the public but they have been available through other suppliers for a very long time. These are considerably longer than stock. They are the correct length to correspond with 4"-5" of suspension lift and will re center your front axle in the fender well as well as providing correct caster angles for drivability and optimal tire wear. These are sold in a set of 4, because you should replace both uppers AND lowers to maintain correct geometry. If you've installed 4" to 5" of lift, you DEFINITELY need longer control arms! This is because as you lift the truck, the angle on the arms increases, pulling it back in the wheel well. These are 1 inch longer than stock. Again, these are brand new. They come ready to install, with zerk fittings, poly bushings, DOM sleeves, etc.

 

What sets our control arms apart from our competition? We use DOM tubing in the construction of the arms AS WELL AS the sleeve the bolt passes through. The problem with the competitors sleeves is they are thin wall rolled over pipe similar to a shock sleeve which leaves a gap/seam. These arms take a lot of pressure during braking and acceleration so over time the competitors sleeves start to pull apart at that seam, which leaves a sharp edge inside the bushing, shredding the bushing from the inside. Our sleeves are heavy wall DOM, with no seam, alleviating this very common problem.

Product Finish: 
These are finished in a heavy black powder coating which gives them elegance as well as extreme durability to the elements. We apply 10 mils of powder and bake at 400 degrees for no less than 20 minutes. The results are a finish that is capable of withstanding anything you can throw at it. 

Hardware: 
This particular kit comes ready to install utilizing your stock hardware.

Instructions: 
All of our products come complete with detailed step by step install instructions to ensure installation is a breeze. Average install time for this kit is 60-90 minutes.

We are located in the heart of East Tennessee and offer full installation services for the products we sell as well as many major lift kit brands. For installation quotes or more info about a product feel free to give us a call


We Also Recommend